MPEG LA 8CH User Manual download pdf (Page 11)

CONNECTION AND SETUP

2-2 To install on the second bracket

Connect the power connector and

data bus connector to the HDD.

When connecting the power cable,

make sure the cable is passed

through the power cable of DVD

writer if your DVR is equipped with

a DVD writer. This is to prevent the

HDD power cable from interfering

with the fan spinning.

Align the screw holes of the bracket

with the HDD’s screw holes. Make

sure the PCB side of the HDD is

facing up. Then, fasten the HDD to

the bracket.

Step3: Close the upper cover of the DVR, and fasten all the screws you loosened in

Step1.

 For 4CH Model

Step1: Loose the screws on the upper cover and remove it from the DVR. Find the hard

disk bracket located on the DVR base.

Step2: Get a compatible hard disk, and connect it to the power connector and data bus

connector.

Step3: Make sure the PCB side is facing up, and place the hard

disk between the hard disk bracket on the DVR base as

shown below.

Make sure the other side of the hard disk is

contacted with the DVR base for heat conduction.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 87 88

No comments

MPEG LA 8CH User Manual Page 11